Gwyscope documentation

open hardware SPM controller with advanced sampling support

User Tools

Site Tools


sidebar

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
sidebar [2025/02/25 10:45] pklapeteksidebar [2025/03/28 12:10] (current) pklapetek
Line 10: Line 10:
   * [[hwboxserver|Starting hwserver]]   * [[hwboxserver|Starting hwserver]]
   * [[hwsvnup|Updating hwserver]]   * [[hwsvnup|Updating hwserver]]
 +  * [[hwperif|Peripherals]]
 +    * [[hwperifpico|Picomotor]]
 +    * [[hwperifthor|Thorlabs]]
 +    * [[hwperifardu|Arduino]]
  
 **Gwyscope GUI** **Gwyscope GUI**
Line 16: Line 20:
   * [[guistart|Installation]]   * [[guistart|Installation]]
   * [[settings|Settings]]   * [[settings|Settings]]
 +  * [[save|Saving the data]]
   * [[scanpath|Scan paths]]   * [[scanpath|Scan paths]]
   * [[lift|Dual path measurement]]   * [[lift|Dual path measurement]]
-  * [[ramp|Ramps]] 
   * [[contact|Contact mode measurements]]   * [[contact|Contact mode measurements]]
   * [[tapping|Tapping mode measurements]]   * [[tapping|Tapping mode measurements]]
 +  * [[qm|Quantitative mechanics (ORT)]]
   * [[akiyama|Sefl-sensing probes (PLL)]]   * [[akiyama|Sefl-sensing probes (PLL)]]
   * [[cafm|Conductive Atomic Force Microscopy]]   * [[cafm|Conductive Atomic Force Microscopy]]
Line 27: Line 32:
   * [[fmkpfm|FM KPFM]]   * [[fmkpfm|FM KPFM]]
   * [[sideband|Sideband KPFM]]   * [[sideband|Sideband KPFM]]
 +  * [[ramp|Ramps]]
   * [[lua|Lua scripting]]   * [[lua|Lua scripting]]
sidebar.1740476722.txt.gz · Last modified: 2025/02/25 10:45 by pklapetek