simple_scan_by_lua_lines
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| simple_scan_by_lua_lines [2026/06/01 15:05] – pklapetek | simple_scan_by_lua_lines [2026/06/01 15:06] (current) – pklapetek | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Lua Line scan ===== | ===== Lua Line scan ===== | ||
| - | This simple client scans topography in contact mode, measuring a collection of individual profiles. | + | This simple client scans topography in contact mode, using Lua script, measuring a collection of individual profiles. |
| It connects to the server and sets the operation regime to proportional feedback (typically used in contact mode, difference between value of signal on input and some setpoint value makes piezo to extend or shrink, depending on settings). Then it sets some basic parameters of feedback loop and sets feedback on. It sets the scanning velocity and then it scans 1x1 micrometer in 50x50 pixels using a Lua script using measurement of individual profiles (lines), which are higher level functions than only individual movements and data storage as shown in [[simple_scan_by_lua|Lua scan example]]. Finally, it stops the feedback, shrinks the z-piezo and exits. | It connects to the server and sets the operation regime to proportional feedback (typically used in contact mode, difference between value of signal on input and some setpoint value makes piezo to extend or shrink, depending on settings). Then it sets some basic parameters of feedback loop and sets feedback on. It sets the scanning velocity and then it scans 1x1 micrometer in 50x50 pixels using a Lua script using measurement of individual profiles (lines), which are higher level functions than only individual movements and data storage as shown in [[simple_scan_by_lua|Lua scan example]]. Finally, it stops the feedback, shrinks the z-piezo and exits. | ||
simple_scan_by_lua_lines.1780319152.txt.gz · Last modified: 2026/06/01 15:05 by pklapetek