Gwyscope documentation

open hardware SPM controller with advanced sampling support

User Tools

Site Tools

Trace:
ramp

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
ramp [2025/02/25 14:30] – pklapetekramp [2025/02/25 14:30] (current) – pklapetek
Line 6: Line 6:
  
 {{ :rampsettings.png?direct&400 |}} {{ :rampsettings.png?direct&400 |}}
 +
 +Clicking to "Store to project" adds the last measured ramp to the project, to be later saved as a Gwyddion file.
  
 As an example, when operated in [[contact|contact mode]], the above settings provide the following result when clicked on "Run single ramp". It shows a force-distance curve. The error signal (measure of force) is upside down (when compared to how it is plotted typically) as in our case the probe-sample detection electronics provides lower signal for higher forces. As an example, when operated in [[contact|contact mode]], the above settings provide the following result when clicked on "Run single ramp". It shows a force-distance curve. The error signal (measure of force) is upside down (when compared to how it is plotted typically) as in our case the probe-sample detection electronics provides lower signal for higher forces.
  
 {{ :rampresult.png?direct&600 |}} {{ :rampresult.png?direct&600 |}}
ramp.1740490217.txt.gz · Last modified: 2025/02/25 14:30 by pklapetek